Riteway Brake Dies
The Pinnacle of Precision Tooling
Hinge & Beading Dies
If press length is a problemm set #124 will provide a clean curl in a one-set two-hit operation.
Die set #121 will produce an off-center curl, 1/4" to 3/4" diameter, in 16 ga. material, in three strokes.
Die sets #122 and #122A should be considered when an accurate on center curl is desired. These dies may be used to produce a curl from 1/4" inside diameter to 1/2" diameter in light gage material. A minimum flat appears on the lead edge, and the sheet remains relatively flat during the forming operation. The sheet to be formed must be wide enough t o provide for a reasonable amount of stock to extend in front of the die sets for safe feeding of the part.
Die sets #123 and #123A produce the tightest and roundest curl that can be formed in two strokes. Dies can be mounted side by side for progressive forming if press has sufficient length.
Die set #125 and #125A is a standard curling die set for regular edge bending. Available for any metal; specify diameter desired.
For producing a radius rib, set #95 is very popular!
Small open hat channels can be produced by set #96!
Set #97 produces a vee rib in one stroke!